-
Power Supply
- Batteries
- Battery Management
- Battery Chargers
- Solar Power
- Wind Generators
- Charging Current Distribution
- Voltage Converters
- Inverter/Charger Combinations
- Conductors and Installation
- Devices and Consumers
- Boat Accessories
- New Products
€1,148.90*
% €1,351.84* (15.01% saved vs. recommended price)will be ordered for you
Lead time: 7 days (according to manufacturer**),
est. total delivery time: 1-2 weeks
Product number:
1587801
EAN:
8719076037538
Manufacturer product ID:
CMP122200000
Please note that our English product descriptions are automatic translations from German. If anything is unclear, please contact us and/or double check the description by the manufacturer. Thanks for your understanding! - your Klabauter Crew
Product information "VICTRON - Multiplus C 12/2000/80-30 - 230V"
The multi-Plus is a powerful inverter with pure sine wave, an advanced battery charger, which uses the adaptive charging technology, and a high-speed AC voltage transfer switch in a single compact
Casing. Apart from these primary functions, the MultiPlus offers even more advanced features that are explained below.
Two AC outputs: the main output provides uninterrupted operation. In the event of a power failure or an interruption of the shore / generator power the MultiPlus takes over the supply to the connected loads. This happens so quickly (in less than 20 milliseconds) that a continuous operation is ensured of computers and other electronic devices. The second output is only supplies current when the multi-Plus AC power is available at one of the inputs. Loads that should not discharge the battery, such. be as a water heater, can be connected to this output (second output is only available in models with an output power of 3000 VA and more).
Practically unlimited performance using parallel circuit: up to six MNCs can be connected in parallel at high power requirements.
Three phase operation: Apart from the parallel port can also three units of the same model for a three-phase output can be configured.
Power Control: Dealing with limited generator, shore side or grid power. With the Multi Control Panel can be adjusted to the maximum generator or shore power. The MultiPlus will then take account of other AC loads and uses to charge only the current that is still "left". Thus, preventing the generator or shore supply from being overloaded.
Power Assist: This feature allows the power control principle on a new dimension. It allows the MultiPlus to support capacity of the alternative sources. Peak power is so often required only for a limited period. In such a case, the multi-Plus ensure that a compensating insufficient shore or generator power immediately by energy from the battery. If the load is reduced, d. H. Consumers are turned off, then back enough available energy can be used to charge the batteries.
Four stage adaptive charger and two batteries: The main output makes using the advanced "adaptive charging" software for a powerful charge to the battery system software fine-tunes the automatic three-stage charging process in order to adapt it to best suit the battery status In addition, it adds.. a fourth stage added for long periods of float charging. Besides that invites the MultiPlus even a second battery by using an independent trickle charge output (trickle charge output only at 12 V and 24 V models available). If settings have to be changed, this can be within a few minutes using carried the new DIP switch setting procedure.
MultiPlus
- Battery voltage 12 V C 12/2000 / 80-30
- Power Control / Power Assist: yes
- Transfer switch: 30 A
- parallel and three-phase operation: yes
INVERTER
- Input voltage range: 9.5 to 17 V (VDC)
- Output: Output voltage: 230 V AC ± 2% Frequency: 50 Hz ± 0.1%
- cont. Output power at 25 ° C: 2000 VA **
- cont. Ausgangsleistg. at 25 ° C: 1600 W
- cont. Ausgangsleistg. at 40 ° C: 1450 W
- Peak power: 4000 W
- Max. Efficiency: 93%
- Zero-load power: 9 W
- Zero-load power in AES mode: 7 W
- Zero-load power in search mode: 3 W
CHARGER
- AC input: Input voltage range: 187-265VAC, input frequency: 45-65 Hz / Power Factor: 1
- Constant Charging Voltage: 14.4 V DC
- Conservation charging voltage: 13.8 V DC
- Storage mode: 13.2 V DC
- Charge current house battery: 80 A
- Charge current starter battery: 4 A
- Battery temperature sensor: yes
GENERAL
- Additional output (A): no
- Programmable relay: relay adjustable u. a. as an alarm relay or Start
- / stop function for an aggregate
- Protection: Output short circuit, overload, battery over-voltage, low battery voltage, over temperature, 230 V AC on inverter output to high input voltage ripple
- VE. Bus Interface: For parallel and three phase operation, remote monitoring and system integration
No: - COM port for general use
- Common features: Operating Temperature Range: -20 to + 50 ° C (forced ventilation), protection class IP21
- Battery connection: M8 bolts
- 230 V AC outlet: spring clip
- Weight: 18 kg
- dimensions (HxBxT): 520 x 255 x 125 mm
** Non-linear load, crest factor 3: 1
Casing. Apart from these primary functions, the MultiPlus offers even more advanced features that are explained below.
Two AC outputs: the main output provides uninterrupted operation. In the event of a power failure or an interruption of the shore / generator power the MultiPlus takes over the supply to the connected loads. This happens so quickly (in less than 20 milliseconds) that a continuous operation is ensured of computers and other electronic devices. The second output is only supplies current when the multi-Plus AC power is available at one of the inputs. Loads that should not discharge the battery, such. be as a water heater, can be connected to this output (second output is only available in models with an output power of 3000 VA and more).
Practically unlimited performance using parallel circuit: up to six MNCs can be connected in parallel at high power requirements.
Three phase operation: Apart from the parallel port can also three units of the same model for a three-phase output can be configured.
Power Control: Dealing with limited generator, shore side or grid power. With the Multi Control Panel can be adjusted to the maximum generator or shore power. The MultiPlus will then take account of other AC loads and uses to charge only the current that is still "left". Thus, preventing the generator or shore supply from being overloaded.
Power Assist: This feature allows the power control principle on a new dimension. It allows the MultiPlus to support capacity of the alternative sources. Peak power is so often required only for a limited period. In such a case, the multi-Plus ensure that a compensating insufficient shore or generator power immediately by energy from the battery. If the load is reduced, d. H. Consumers are turned off, then back enough available energy can be used to charge the batteries.
Four stage adaptive charger and two batteries: The main output makes using the advanced "adaptive charging" software for a powerful charge to the battery system software fine-tunes the automatic three-stage charging process in order to adapt it to best suit the battery status In addition, it adds.. a fourth stage added for long periods of float charging. Besides that invites the MultiPlus even a second battery by using an independent trickle charge output (trickle charge output only at 12 V and 24 V models available). If settings have to be changed, this can be within a few minutes using carried the new DIP switch setting procedure.
MultiPlus
- Battery voltage 12 V C 12/2000 / 80-30
- Power Control / Power Assist: yes
- Transfer switch: 30 A
- parallel and three-phase operation: yes
INVERTER
- Input voltage range: 9.5 to 17 V (VDC)
- Output: Output voltage: 230 V AC ± 2% Frequency: 50 Hz ± 0.1%
- cont. Output power at 25 ° C: 2000 VA **
- cont. Ausgangsleistg. at 25 ° C: 1600 W
- cont. Ausgangsleistg. at 40 ° C: 1450 W
- Peak power: 4000 W
- Max. Efficiency: 93%
- Zero-load power: 9 W
- Zero-load power in AES mode: 7 W
- Zero-load power in search mode: 3 W
CHARGER
- AC input: Input voltage range: 187-265VAC, input frequency: 45-65 Hz / Power Factor: 1
- Constant Charging Voltage: 14.4 V DC
- Conservation charging voltage: 13.8 V DC
- Storage mode: 13.2 V DC
- Charge current house battery: 80 A
- Charge current starter battery: 4 A
- Battery temperature sensor: yes
GENERAL
- Additional output (A): no
- Programmable relay: relay adjustable u. a. as an alarm relay or Start
- / stop function for an aggregate
- Protection: Output short circuit, overload, battery over-voltage, low battery voltage, over temperature, 230 V AC on inverter output to high input voltage ripple
- VE. Bus Interface: For parallel and three phase operation, remote monitoring and system integration
No: - COM port for general use
- Common features: Operating Temperature Range: -20 to + 50 ° C (forced ventilation), protection class IP21
- Battery connection: M8 bolts
- 230 V AC outlet: spring clip
- Weight: 18 kg
- dimensions (HxBxT): 520 x 255 x 125 mm
** Non-linear load, crest factor 3: 1