Sichere und zuverlässige Steckverbindungen an Bord

Gerade in der feuchten, oft salzhaltigen Atmosphäre an Bord von Sportbooten müssen Steckverbindungen einiges aushalten. Um Spannungsverluste und Lichtbogenfehler zu verhindern sind daher qualitative Verarbeitung und eine dem Einsatzzweck entsprechende Wahl des Steckers sehr wichtig.

Wir haben hochqualitative Steckverbindungen für sämtliche Einsatzzwecke an Bord im Angebot:

Standard-Stecker für 12/24 Volt-Systeme
Hochstrom-Stecker bis zu 120-Ampere
Eine große Auswahl verschiedener Steckertypen für einen fachgerechten Landanschluss und Antennenstecker
Spezielle wassergeschützte Stecksysteme für die Außenmontage
KFZ-Anhängerstecker und USB-Steckdosen und -Adapter

Backordered

Philippi - Ratio - Schuko socket, stainless steel, IP56

The installation-Schuko socket has been specially designed for installation on the deck of yachts.The compact waterproof stainless steel housing (IP56) adapts shapely and inconspicuously on deck.The Schukop socket optically fits perfectly with the land connection sockets from the manufacturer Ratio.Outside diameter 87mmInstallation hole diameter 55mmInstallation depth 52mmAttention: This Schuko socket must not be used for the feed -in of country power into the ship.It only serves to connect 230V consumers outdoors.

€111.90* €118.00* (5.17% saved vs. recommended price)

2 in stock

Connector Kit German 2-pole Spillproof female,

enables safe and protected electrical connection from 2-pin cables up to 13a electricity

€4.55* €4.90* (7.14% saved vs. recommended price)

11 in stock

Philippi - RS694 - angle assembly housing

Angle housing for the deck structure of RS694 flange plugs, which was angled 90 degrees, or flange box. Dimensions (LXBXH): 74 x 70 x 52 mm.

€16.90* €17.90* (5.59% saved vs. recommended price)

90 in stock

FME coupling for RG58

The FME coupling is crimped onto the antenna cable with the cable inner light and the cable shielding. Plug adapters can then be screwed onto this coupling for different plug -in forms. An FME connector can be used for the opposite side to manufacture a separation point.-Iity connection without soldering through crimp pressures.-Sauver assembly with very low transition resistance-"Cold" soldering connections in cold and wind.-No -corrode corrode the soldering under the influence of the aggressive sea clima.Suitable for coaxial cable RG58.Not suitable for low-loss cable H2005 or Aircell 5!

€3.28* €3.70* (11.35% saved vs. recommended price)

125 in stock

PL connector for RG58 / H2005

Suitable for coaxial cable with 5 mm in outer diameter, e.g. RG58, H2005 or Aircell 5. Cable installation by solder joint.

€4.40* €4.90* (10.2% saved vs. recommended price)

43 in stock

Plug 2 -pin - brass chrome -plated - 3 a

Brass contacts with a screw connection.Total height with socket: 55 mm.Not 100% waterproof!Please order the socket separately.

€8.40* €9.90* (15.15% saved vs. recommended price)

75 in stock

Splitter 2 -pin - brass chrome -plated - 3 a

Mounted socket with cap.Brass contacts with screw.DimensionsFlange diameter: mm 37,External thread -Ø: 21.4 mmHeight with plug: 55 mm.Not 100% waterproof!Connector to be ordered separately.

€8.40* €9.90* (15.15% saved vs. recommended price)

Backordered

PL connector for H2007 / Aircell 7 cable

Suitable for H2007 LOW LOSS or AIRCELL 7 - cable.

€9.70* €10.90* (11.01% saved vs. recommended price)

93 in stock

FME connector for RG58

The FME connector is crimped onto the antenna cable with the cable inner light and the cable shielding.-Iity connection without soldering through crimp pressures.-Sauver assembly with very low transition resistance-"Cold" soldering connections in cold and wind.-No -corrode corrode the soldering under the influence of the aggressive sea clima.Suitable for coaxial cable RG58.Not suitable for low-loss cable H2005 or Aircell 5!

€2.09*

2 in stock

Philippi - RS692 - clutch can, 3 -pole, 16 A / 230 V

-High permissible rated current-Schraubanschlüsse-Small dimensions-Easy and secure screw closures-Large connection compartment for simple and easy cable installation-Also for 230 volts shore supply suitable number of poles: 2 + PE / 3-Anschlussquerschnitt max. : 2.5 mm²-Anschlussart: Screws-Kabeldurchlass 10-12 mm-Kontaktoberfläche: Ag-Protection according to VDE IP 66-Gehäusematerial: PBT gv-Nennstrom each contact 16 AVoltage rating in accordance with VDE: 230 V-Brennbarkeit UL-94: self-extinguishingsimilar image

€20.40* €21.80* (6.42% saved vs. recommended price)

13 in stock

PL connector Crimpio version for RG58 / H2005

Suitable for coaxial cable with 5 mm in outer diameter, e.g. RG58, Aircell H2005 or fifthThe outer conductor is crimped. The inner conductor is to be soldered.

€5.50*

111 in stock

Push on boot for cable RG 174/U

Knickschutztülle schwarz, für Kabel RG 174/U

€0.85* €0.90* (5.56% saved vs. recommended price)

2 in stock

Philippi - RS692 - flange box, 2 -pin, 16 A / 50 V

-Hher permissible nominal current-Screw connections-Kleine dimensions-Calm and safe thread locking-Large connection room for simple and light cable assembly policies: 2-Connection cross -section max.: 2.5 mm²-type: screws-Kabeld defeat: 6-8 mm-Kontakt surface: AG-Protection type according to VDE: IP 66-CHASE MASS: PBT-GV-Nenstrom per contact: 16 a-Nn voltage according to VDE: 50 V-Brill after UL-94: non-flammable

€8.90* €9.40* (5.32% saved vs. recommended price)

Backordered

FME coupling for H2005 / Aircell 5

The FME coupling is crimped with the Kabelinnenlitze and the cable shield of the antenna cable. It can then plug adapters are screwed for different plug standards in this coupling. To produce a separation point a FME connector can be used for the opposite side.-Dauerhafte connection without soldering by crimping pressures.-Clean assembly with very low contact resistance-No "cold" solder joints in the cold and wind.-No corrosion of the solder under the influence of aggressive maritime climate.Especially for low-loss cable H2005 or Aircell 5!

€5.90*

1 in stock

Philippi - Magcode 12V Magnet Plug Mcs

Voltage: 12 VRated current: 16 ACable section: max. 2.5 mm²Plating: silverTermination: ScrewTemperature range: - 25 ... + 85 ° CHousing: PlasticDimensions Ø 37 x L 84 mm x H 18 mm

€21.90* €22.90* (4.37% saved vs. recommended price)

6 in stock

Philippi RS692 - Land connection connector - 230 V / 16 a

Particularly compact and waterproof 230 V / 16 A shore power connectorConsisting of:Flanschgerätesteckdose with protective cap,Angle housing andShore power connector with protective cap.- 230 V / 50 Hz, max. 16 A- IP 66- 2 pole + earth- 2 caps- plus dimensions of the plugged connection cable entry (LxWxH): 135 x 53 x 36 mm.

€52.40* €55.50* (5.59% saved vs. recommended price)

5 in stock

PHILIPPI - RS692 - coupling plug, 2-pole, 16 A / 50 V

- High permissible nominal current- screw connections- Small dimensions - length approx. 92mm, Ø 29mm- Simple and safe thread locking- Large connection room for simple and light cable assembly- Pole number: 2- Connection cross -section max.: 2.5 mm²- Connection type: screws- cable passage: 6-12 mm- Contact interface: AG- Protection type according to VDE: IP 66- Housing material: PBT-GV- Nominal current per contact: 16 a- Nominal voltage according to VDE: 50 V- flammability according to UL-94: non-flammable

€10.90* €11.60* (6.03% saved vs. recommended price)

18 in stock

PHILIPPI - RS692 - angle mounting housing

Angle housing for the cover structure of RS692 flange plugs, or flange box. Dimensions (LXBXH): 56 x 53 x 36 mm

€7.90* €8.40* (5.95% saved vs. recommended price)

30 in stock

FME connector for H2005 / Aircell 5

€3.49* €3.90* (10.51% saved vs. recommended price)

38 in stock

FME coupling for RG174

€3.70*

5 in stock

PHILIPPI - RS692 - socket, 3-pole, 16 A / 230 V

-High permissible rated current-Schraubanschlüsse-Small dimensions-Easy and secure screw closures-Large connection compartment for simple and easy cable installation-Also for 230 volts shore supply suitable -Polzahl: 2 + PE / 3-Anschlussquerschnitt max. : 2.5 mm²-Anschlussart: Screws-Kabeldurchlass 10-12 mm-Kontaktoberfläche: Ag-Protection according to VDE IP 66-Gehäusematerial: PBT gv-Nennstrom each contact 16 AVoltage rating in accordance with VDE: 230 V-Brennbarkeit UL-94: self-extinguishingsimilar image

€13.90* €14.50* (4.14% saved vs. recommended price)

Backordered

Philippi - USB built -in socket USB C/A 3.6 ampere

USB Outlet12 / 24V DC / DC 5 V 1x2,5A, Type USB3Suitable for charging and operation of cell phones, digital cameras and other devices with USB interface. The integrated DC-DC converter generates the required 5 V operating voltage.DC 12 V or 24 V 2500 mA. Hole diameter 28 mm, fixing by means of hexagon nut. As can be seen in the figure, these mounting box has no Abdeckungl

€28.90* €30.70* (5.86% saved vs. recommended price)

Backordered

Philippi - Magcode 12V Magnet flange box MCF

Nominal voltage: 12 VNominal current: 16 aConnection cross -section: max. 2.5 mm²Contact interface: silver -platedConnection type: flat connector 6.3 mmTemperature range: - 25 ...+ 85 ° CHousing material: plasticThe surface of the flange box is waterproof.Dimensions Ø 37 mm, assembly hole Ø 28 mm, installation depth 22 mm

€23.40* €24.60* (4.88% saved vs. recommended price)

19 in stock

FME connector for RG174

The FME coupling is crimped with the Kabelinnenlitze and the cable shield of the antenna cable.-Dauerhafte connection without soldering by crimping pressures.-Clean assembly with very low contact resistance-No "cold" solder joints in the cold and wind.-No corrosion of the solder under the influence of aggressive maritime climate.

€2.11* €2.40* (12.08% saved vs. recommended price)

Filter products

Sichere und zuverlässige Steckverbindungen an Bord