Geräte und Verbraucher: Bordelektronik & Co.

For Wib1, WiB2, WIB2D, Wib3 and Wibe.Offers space for the device and accessories such as load adapter and USB cable.Dimensions approx. (WXHXT): 170 x 160 x 45 mm

socket Ba9sPart No .: 6863012 V, 5 WPart No .: 6863112 V, 20 WNot suitable for use on motor vehicles!

ACTISENSE - NMEA 2000 Kabel Meterware

Adapter version G4-GY6.35 on base BA15D for LED lampsThis adapter has two contacts for the power supply below, the pins on the side are both at the same height.These adapters enable the use of LED or halogen lamps with G4/GU4 base in all lights with a 15 mm bayonet frame.Depending on the requirement, you can also use cylindrical lamps with a large beam angle or spots in your existing lights.Color: white/silverVersal type (standard designation): G4/ GU5.3/ GY6.35Base type (standard designation): BA15D (in Figure 3 in the middle)Dimensions: Ø 17 mm x 29 mmWeight Bulk: 8 gArea of application: 10 - 30 V Niedervolt, LED lampsScope of delivery: 1 adapterThis article can only be used for the naval area.The usual use of this BA15D is a single -down lamp with potential -free base (e.g. anchor light in boats or in the vehicle interior). The BA15D cannot be used as a replacement for a doubt lamp (brake and bottom).Use as a lamp in motor vehicles is not permitted and permissible.

4 veins plus shieldingCable outer diameter 4.6mmThe prices are given for cuts per meter. Special prices for entire rings or roles are available. If necessary, simply inquire about the required amount. Discount of 10 % when decreasing ≥ 50 m and 15 % when accepting ≥ 100 m. The discount is automatically taken into account when determining price.

LEDs with low power consumption of max 15mA for direct connection to 12 / 24V (30V DC). required holes: 4.2 mm Ø

MARINE LED range- Very low power consumption- Pleasant warm white light color- The light color corresponds to conventional incandescent lamps- Large input voltage range, suitable for 12 and 24 V systems- Insensitive against voltage spikes (by dynamo, charger, etc.)- "burn out" prevents Integrated voltage regulation and guarantees long service life- The lamps with integrated power control function independently of the polarity- In connection with an electronic dimmer (pulse width modulation), the LED can be dimmed- Due to continuous development we reserve the right without notice in design and specifications to supply different items successor.- Energy efficiency class A +15 SMD LED.The design corresponds to a conventional light bulb, the filament was replaced by a SMD LED insert!Bayonet base with two Fußkontakten (BA15d) - (Picture 2 in the middle)Series: 15er SMD Globe with bayonet baseLuminous flux output typ .: 140 lumensColor temperature: warm white (2700 Kelvin)CRI:> 80Rated / rated life: up to 50,000 hLumen maintenance: 0.7Angle: 300 °Socket type (standard designation) BA15dConsumption: 1.6 wattsInput voltage: 10 - 30 V DC / 10 - 18 V AC at 50/60 Hz effectivelyReplaces: about 15-20W bayonet lamp *Dimmable: YesDimensions: Ø 25mm x 48mmWeight: 12 gWeight in blister: 23 gSwitching cycles:> 25,000Color Consistency: SDCM <7 (Standard Deviation of Color Matching)Energy efficiency class: A +Delay: none (<1 sec.)Power Factor: 0.8This article is to be used only for the marine sector.The usual use of these BA15D than single filament with floating base (e.g. anchor light on boats or in the vehicle interior). The BA15D can not be used as a replacement for a two-filament lamp (brake and tail light)The use as light source in motor vehicles is not permitted and prohibited. * 15 W as shown in Table 6 of the EU Regulation 244/2009Consumption in W was for decades as a benchmark for lamps alternatives.However, the prescribed formulas for determining equivalence do not necessarily reflect the realistic replacement again.The subjective perception of brightness of an LED lamp is highly dependent on the positioning and type of light.Most LED lamps emit light mainly in one direction. As a result, lamps are felt with a low equivalent value, according to the EU regulations as significantly brighter.

Montagewinkel für WIB3S/WIB4S

Dimensions (Durchm.xL): 20 x 85 mmItem No .: 6772 A12 V, 25 W, BA15d (picture 2 left side)This article is to be used only for the marine sector.The use as light source in motor vehicles is not permitted and prohibited.

Total length about 65 mm, E14Part No .: 673812 V, 10 W, E14 6800 24 V, 10 W, E14Part No .: 6792712 V, 15 W, E14 6801 24 V, 15 W, E14Part No .: 674012 V, 25 W, E14 6802 24 V, 25 W, E14

The mounting frame is made of the same material as the Wetterinfobox.The carrier plate is 5 mm thick.The Weatherinfobox is used there at the device without changes.The mounting frame has the dimensions: 180 x 140 mmsold the mounting frame- without the pictured WIB4S - the image is only an impression!

Eine Abdeckkappe zum Schutz eines nicht verbundenen Micro-C-Verbinders (männlich).

Ersatz für die Befestigung der Montagewinkel am Gehäuse der WIB 3S / 4S

Adapter holder G4-gy6.35 on E14 for LED lamps. Caution only use Niederspannug 10-30V!These adapters allow the use of LED or halogen Leuchitteln with G4 / GU4 base in all lights with 14mm screw mount.You can thus, depending on requirements and cylindrical Leuchittel with wide viewing angle or spots in your existing luminaires use.Color: white / silverSocket (standard designation): G4 / GU5.3 / GY6.35Socket type (standard designation) E14Weight bulk: 5 gScope: 10 - 30 V low-voltage, LED lampsWe expressly point out that navigation lights lose the authorization for use of this base with corresponding Leuchitteln. The base may therefore only for decorative purposes and are not used for operation on maritime and inland waterways!